7
Original instructions
EN
tending beyond the sanding pad presents
a laceration hazard and may cause snag-
ging, tearing of the disc or kickback.
Safety Warnings Specific for Polishing
Operations:
a)
Do not allow any loose portion of the
polishing bonnet or its attachment
strings to spin freely. Tuck away or trim
any loose attachment strings. Loose and
spinning attachment strings can entangle
your fingers or snag on the workpiece.
Safety Warnings Specific for Wire
Brushing Operations:
a)
Be aware that wire bristles are thrown
by the brush even during ordinary op-
eration.
Do not overstress the wires by ap-
plying excessive load to the brush. The wire
bristles can easily penetrate light clothing
and/or skin.
b)
If the use of a guard is recommended for
wire brushing, do not allow any interfer-
ence of the wire wheel or brush with the
guard.
Wire wheel or brush may expand in
diameter due to work load and centrifugal
forces.
V - Know your product
Before using the power tool, familiarize your-
self with all the operating features and safety
requirements.
Use the tool and accessories only for the ap-
plications intended. All other applications are
expressly ruled out.
1. Spindle
2. Spindle lock button
3. ON/OFF switch locking button
4. ON/OFF switch
5. Thumbwheel for electronic speed pre-
selection
6. Closed auxiliary handle
7. Washer
8. Bolt
9. Hook-and-loop flexible backing pad
17. Spanner SW 22
ACCESSORIES TO BE USED WITH
THIS POWER TOOL
6b. Side auxiliary handle
9b. Flexible backing pad with support flange
and fixing flange
10. Hook-and-loop operating tool
(soft intermediate disc, abrasive sheet,
sponge, felt wheel, lambswool polishing
bonnet)
11. Operating tool with flange and nut
(cloth wheel, sponge, felt wheel,
wire brush)
12. Side handle guard
13. Support flange
14. Fixing flange
15. Abrasive sheet (sandpaper)
16. Lambswool polishing bonnet
18. Pin spanner
VI - Operation
These power tools are supplied from single-
phase alternating current mains only. They are
double insulated according to EN 60745-1,
IEC 60745-1 and can be connected to grounded
or not grounded sockets. This power tool is ra-
dio suppressed in compliance with EMC Direc-
tive 2004/108/EC.
This power tool is designed for rough and fine
dry grinding, refurbishing and brushing, polish-
ing and rubbing all kinds of surfaces at optimum
chosen rotation speed.
PRIOR TO INITIAL OPERATION
▪ Make sure the power supply voltage corre
-
sponds to the value indicated on the name
plate with technical data of the tool.
▪ Always check the position of ON/OFF switch.
The power tool must be connected to the
power supply socket only when this switch is
in OFF position. If the plug is connected to
a receptacle while the power switch is in the
ON position, the power tool will start operat-
ing immediately, which could cause a serious
accident.
▪ Make sure that the cord and the plug are in
order. If the replacement of the supply cord is
necessary, this has to be done by the manu-
facturer or his agent in order to avoid a safety
hazard.
WARNING:
Always switch off and un-
plug the power tool prior to any adjustment,
servicing or maintenance.
▪ In case the work area is remote from the pow
-
er source, use as short as practicable exten-
sion cord with proper cross-section.
Та
ше
в
-
Га
лв
ин
г
ОО
Д
www.tashev-galving.com
