8
EN
TK 70
DUST CAPTURING
The circular saw may be completed in addition
with dust capturing adapter. Place adapter 14 on
guard cover and fix it by screw 15 and washer
16. This adapter fits vacuum cleaners with Ø35
hose orifice.
ACCESSORIES TO BE USED WITh
ThIS POWER TOOL
Carbide-tipped blade
Blade diameter - Ømax200 mm
Blade arbour - Ø30 mm
VII - Maintenance
WARNING:
Always ensure that the
tool is switched off and unplugged before
attempting to perform inspection or mainte-
nance.
BRUSh REPLACEMENT
This power tool is equipped with auto-stop
brushes. When the carbon brushes are worn
out, the machine switches itself off. In this case
both brushes must be replaced simultaneously
with genuine brushes at SPARKY service centre
for warranty and post-warranty service.
GENERAL INSPECTION
Regularly inspect all fasteners and ensure they
are properly tightened. Should any of the screws
be loose, retighten it immediately to avoid haz-
ards.
If the replacement of the supply cord is neces-
sary, this has to be done by the manufacturer or
his agent in order to avoid a safety hazard.
CLEANING
For safe operation always keep the machine
and its ventilation slots clean.
Regularly check to see if any dust or foreign
matter has entered the ventilation slots and the
grills around the switches. Use a soft brush and/
or air jet to remove any accumulated dust. Wear
safety glasses to protect your eyes whilst clean-
ing.
Exterior plastic parts may be cleaned with a
damp cloth and mild detergent if necessary.
WARNING:
Never use alcohol, petrol
or other cleaning agent. Never use caustic
agents to clean plastic parts.
WARNING:
Water must never come
into contact with the tool.
IMPORTANT!
To assure product safety and re-
liability, repairs, maintenance and adjustment
(including brush inspection and replacement)
should be performed by certified service centres
or other qualified service organisations, always
using genuine replacement parts.
Та
ше
в
-
Га
лв
ин
г
ОО
Д
www.tashev-galving.com
