ARISM m i n i
User’s Manual
Product Set Up
Copyright © 2018 ANEST IWATA SPARMAX Co., Ltd. All rights reserved.
SP_MAN_ARISM MINI_A4_20180817
1. First use: Carefully unpack the unit, verify that all parts listed in the “Parts List” are present, and visually inspect for damage. If there are any
signs of damage or if any parts are missing, do not use the product. Contact your retailer or supplier immediately.
2. Place the compressor in a clean, dry, and well-ventilated area that has adequate air circulation.
3. Screw one end of the braided air hose onto the compressor’s Air Outlet located below the pressure adjustment knob, and the other end of the
hose to the airbrush.
Product Operation
www.SPARMAXair.com
1. Insert the plug into a working power outlet. Turn the compressor on by pressing the On/Off Switch.
3. When the airbrush is not in use, it may be placed into the Airbrush Holder.
NOTE: Please make sure the airbrush stays
in the holder like the picture bellow.
2. To adjust air pressure, turn the pressure adjustment knob clockwise to increase air pressure, or counter-clockwise to decrease air pressure.
Troubleshooting
If airflow is not sufficient …
• Check for air leaks where air can be heard escaping, or apply a soap and water solution on all connections. Resulting bubbles indicate an air leak.
Tighten fittings where necessary.
• PTFE seal tape is recommended for all threaded connections.
• Replace the Air Hose if the hose is torn or damaged.
If compressor shuts off frequently, the motor fails to come up to full speed or becomes hotter than usual during operation …
• Disconnect other appliances that are using the same power outlet.
• Avoid using extension cords.
If problems arise which you cannot solve with the information provided above, please contact your retailer or supplier for assistance. Do not
attempt to fix the device yourself. Improper operation and/or dismantling of the device may damage the compressor. If any parts/accessories are
damaged, please contact your retailer or supplier for replacement or repair.
4. When using the holder, please be sure to rest the front of the airbrush securely in the holder.
5. Do not touch any exposed metal parts on the compressor during, or immediately after, operation. The compressor will remain hot for several
minutes after operation.
6. It is recommended that the compressor run continuously for no more than 30 minutes. After 30 minutes of continuous operation, use the
On/Off Switch to turn off the unit. Allow the unit to cool for 10 to 15 minutes before turning the compressor back on.
7. The compressor has a thermal safety switch which automatically ceases compressor operation when the compressor becomes too hot. If this
happens, use the On/Off Switch to turn off the compressor. Allow the unit to cool for 10 to 15 minutes before turning the compressor back on.
8. After each use, make sure the unit is turned off and unplugged. Also be sure to release any remaining air from the compressor by depressing
the airbrush trigger.
1
0
4
3
2
5
Summary of Contents for ARISM mini
Page 3: ......
