Ethernet Adaptor 01-103
Sparr Electronics Ltd., Bangalore
8
Enter the correct Host Name (IP Address) and the Port number. Host Name is the IP
address you programmed and assigned to your EAD01-103, for example 192.168.0.254.
The reserved Port number in EAD for configuration through Telnet is
7353.
Click on
„Connect‟ and enter the Password when prompted. Default password is 77277. Change
the parameters as per your choice. For detailed description on parameters of EAD, see
later section.
Note: -
If you want to program through the Telnet then the Port number should
always be
7353.
The telnet command and options screen will look same under Windows 2000 and XP where
you will have to use > open 192.168.0.254 7353 after issuing Telnet command in the Run.
5.3. Auto IP Programming
If the user knows only the MAC address of the EAD and doesn‟t know the IP address
then you can program it by adding “arp” (Address resolution Protocol) entry in his
Computer and then connect through telnet using that IP and port number 7353.
For adding the “arp” entry, go to the DOS or Command prompt in your PC and enter the
IP and MAC address as below.
C:\> arp –s [IP address] [MAC Address]
For example: -
Figure. 8. Auto IP Programming using arp
Once the Arp entry is added, try to ping the EAD using the command:
Ping [IP address] –l 102
and ensure the ping response is successful.
You can now program the EAD through Telnet program. Enter the Host Name as the IP
that you set in your system ARP table, and the Port should be
7353.
Follow the steps mentioned above for programming through Telnet and setup the EAD as
you require.
