Ethernet Adaptor 01-103
Sparr Electronics Ltd., Bangalore
13
6
EAD Setup Parameters
The Main Configuration Menu items are listed and explained below.
a)
Network configuration
b)
Serial configuration
c)
Server configuration
d)
Load factory defaults
e)
Change configuration password
f)
Save and Exit
g)
Exit
h)
To upload new firmware
.
i)
Enable Boot Messages 0=Disable 1=Enable
In the
Network configuration
section there are eight parameters as mentioned below.
a)
IP Address
b)
Netmask
c)
Gateway
d)
DNS IP Address
e)
Port number
f)
Exit
g)
Transport protocol 0 = TCP 1 = UDP
h)
Network Interface
i)
DHCP 0=Disable 1=Enable
Under the
Serial configuration
menu, there are seven parameters:
a)
Baud rate
b)
Data Parameters
c)
Flow control
d)
Serial I/F Mode
e)
Character wait timeout [00 – 254 msec]
f)
Inter Character delay [00- 254 msec]
g)
Connection status reporting. 0=Disable 1=Enable
h)
XON-XOFF pass through, 0=Disable 1=Enable
i)
Exit
Under the
Server configuration
menu, there are fifteen parameters:
a)
IP Filtering
b)
Start mode
c)
Accept incoming connection, 0 = Disable , 1= Enable
d)
Remote IP address
e)
Remote Port number
f)
Send CR with LF, 0 = Disable, 1= Enable
g)
Accept serial data when not connected, 0 = Disable, 1= Enable
h)
No. Of characters in a Packet 1 - 254
i)
Connection Inactivity Timeout [1 - 65534 Sec, 65535 to Disable]
j)
Disconnect Active connection on Data
k)
Disconnect Active connection on DSR 0=Disable 1=Enable
l)
Packet Data 0 = Disable 1 = Enable
m)
DTR active on Connect Only 0=Disable 1=Enable
n)
Exit
