-
24-
CAB TILT PROCEDURES
CAB TILT:
1.
Master Battery Switch “ON”.
2.
Engine not running.
3.
Parking Brake Engaged. (Wheels Chocked)
4.
Move the front suction swivel to the FORWARD position.
5.
(This usually requires stretching out the soft suction)
6.
Check the front bumper area for any other items (including hose butts etc.) that
may interfere with the raising of the cab.
7.
Check and remove/secure any loose items from within the entire cab area. S.C.B.A.
harnesses should be removed from all forward facing seats.
8.
Make certain that all doors are secured in the closed position.
9.
Make certain that the deck gun is resting in the cradle supplied.
10.
Front wheels must be pointed forward.
11.
Check for adequate (15 FEET MINIMUM) overhead clearance.
12.
Remove upper portion of pump panel on officer’s side of apparatus to access cab lift
controls.(
See Figure 19
)
13.
Push and hold electric tilt switch “UP” button until cab tilts and manual safety
holding device falls into place. (
See Figure 20
)
14.
Push electric tilt switch “DOWN” button until cab rests on the manual safety holding
device.