GB
14
Linear 4S or Prestige models:
1. Apply slight downward pressure to the door handle to tilt the door down-
ward a little whilst also supporting the fire compartment door hand at the
top with the other.
Now clean the glass pane as per the instruction manual.
Closing the fire compartment door:
1. Gently close the fire compartment door.
2. Using the “cold hand“, twist the catch above the door back to its end stop.
This is important, since the catch might otherwise be obstructed in in the
cover and prevent the door from sealing.
3. Test the proper operation of the door by sliding upward and then re-
checking the catch on top to ensure it rests against its stop.
Use only the handle/”cold hand” to open and close the door. Never apply
pressure to the glass panes! DANGER OF BREAKING!
4.5.2 CLEANING ROUND OR ANGLED UPWARD
SLIDING DOORS
Close the fire compartment door (slide down fully). Place the “cold hand” on
the slide rail locking mechanism above the fire compartment door.
(Attention! One- or two-sided, depending on model). Twist to the right to
push the bolt for the locking mechanism forward by 90 degrees (to under
the door cover).
Place the “cold hand” on the lever/locking
device on the right hand side of the door
and twist upward.
Swing open the door for cleaning.
Using one hand, tilt the door open
up to its end stop.
Turn the lever to right to lock the lifting
mechanism.
