20
8.As using water power massage, don't use the excessive plant cosmetics, in case that the
screen panel of return water be jammed.
9.Should clear up the return water screen panel of the water pump for using every 30hours,
so as not to be jammed.
10.If not use for a long time, should close the master power, for fear that the machine be in
the state of waiting for a long time.
11.As water in the bathtub is higher than the spray nozzle, can you turn on the water pump,
and the operation of the electrical engine of the water pump has stopped, can you drain off
water. For fear that damage the water pump as it runs in idleness at the state of no water.
12. After the bathtub been installed, seal up all connection slot between the bathtub and the
wall body with the white neutral glass cement and can use it formally 24 hours later
13.Before and after the use of this equipment it should be notice to the cleanness sanitation;
In order to aviod any damage to the equipment it’s not allow too rude to use this equipment. Do
not touch with such as ink or feculency to the crust of the equipment; after each use, it’s request
to clearn with soft cotton towels lightly and let it dried naturally; In order to avoid circuit fault,
the circuit can not contact with the water during clearning.
14.The grounding quipment should always be connected to the f ixed cabling.
15.It should be install a whole extreme switch on the location of over 3mm of the connection
point in the f ixed cabling.
6.Maintenance of the bathtub: As the bathtub has the scale or slight scotch, can polish it with
toothpaste and soft cloth.
7.Washing the water power massage device: Add hot water of 40ºC to the bathtub to full,Put
into sanitizer 2 gram per liter water,Start the water power massage system about 5 minutes,Stop
the pump and drain off water, then add the cold water fully,restart about 3 minutes of water
power massage,clean bathtub after stopping the pump and draining off water.
18.If the electrical line damage, it should be call for a professional electrician to check so that
can aviod the danger.
16.In the cold winter ,the temperature should not be set too high when you use it f irst , set
the steam temperatures slightly higher than the room temperature, then you should raise the
temperature twice till you need.
17.The old hose do not allow repetition use, it should be use the new hose which was
accompanying with this equipment.
