6. Connecting power supply precautions
WARNING! Before any operations carried out on the device pull the plug out of the power
socket.
1. Make sure that the device is not connected to the electricity
2. Check if the ground wire has a clamp or screw clamp
3. Connect the ground clamp to the socket on the front panel with proper polarization.
4. Insert the torch plug into the socket on the panel and tighten it.
7. Cleaning and maintaining the device
The protection class of this device is IP21S. Do not use the device in the rain, nor expose it to
extensive moisture.
WARNING!
Device based on electronic components. Metal grinding and cutting close to the welder
may cause contamination of the inside of the device, thus causing its damage.
The damage mentioned above is not covered by the warranty. If you need to work in such
an environment, please clean device before use by blowing the inside of the welding
machine with compressed air.
To prolong the life and reliable operation of the device, several rules must be observed:
1. The device should be placed in a well-ventilated room where there is free air circulation.
2. Do not place the device on a wet surface.
3. Use a wire diameter and spool weight according to the table.
4. Check the technical condition of the device and welding cables.
5. Remove any flammable materials from the welding area.
6. Use suitable protective clothing for welding: gloves, apron, safety boots and welding helmet
8. Transporting and storage
Always store the devices in a dry, ventilated place, out of reach of children and
bystanders. Protect the device against vibrations and shocks during transport.
9. Recycling
The packaging and device materials are suitable for recycling use. Disposal of the packaging and
device must be done in accordance with local regulations. The packaging materials should be
protected against children as they are potential source of danger.
10. Warranty
The manufacturer of the device provides full warranty service for the power supply unit within 24
months from the day device was purchased. An individual warranty card is issued for each device.
Warranty is valid only if all conditions listed in the instructions manual were fulfilled. If the device
was used inappropriate or against instructions the warranty becomes invalid. Service centre does
not cover the postage cost for sending the device for repairs or sending it back after repairs.
Spaw S.C.
– Service Centre
ul. Kosiarzy 3
30-731 Krakow
Poland
phone: +48 123 480 722
repair request form - www.spawsc.pl - service tab.
