AFTER SALES SUPPORT
0345 605 2070
23
MAINTENANCE
Warning:
Disconnect the power source before
servicing, sever injury or death could occur
from electrical shock or body contact with
moving chain.
Warning:
Cutting edges or chain are sharp, use
protective gloves when handling chain.
Warning:
Do not use water, solvents or polishes
as medium for clearance and maintenance.
Remove all debris, especially from the motor
cooling vents.
Loosen the bar locking knob(the inner circle) anti-
clockwise slightly, but
do not remove the side cover.
Hold up the nose of the guide bar and turn the chain
tensioning knob(the out circle) clockwise.
When the saw chain is tensioned with 9N (approx.1kg),
the gap between the saw chain and the guide rail
should never be more that 2mm.
Do not over tension the chain as this will reduce life of
chain bar and motor. With a correctly tensioned chain
you will get good cutting performance and a longer
life.
Max.2mm
9N
Adjust the chain tension
