26
AFTER SALES SUPPORT
0345 605 2070
MAINTENANCE
• Place the chain tensioning gear on the side of the
guide bar facing you such that the rectangular
piece does not protrude past the edges of the
guide bar and replace the screw.
• Place the guide bar on the bar pad by sliding the
bar slot over the alignment flange.
Remove guide bar from chain saw. remove sawdust
from guide bar groove periodically. use putty knife
or wire. clean oil slots after each day of use. remove
burrs from sides of guide bar. use flat file to make side
edges square.
Inspect guide bar before sharpening chain. A worn
or damaged guide bar is unsafe. A worn or damaged
guide bar will damage chain, it will also make cutting
harder. replaces guide bar if this occurs.
BAR PAD
ALIGNMENT FLANGE
MOUNTING STUD
IMPORTANT!
Remove and brush clean the cover
plate, chain and chain bar after 1 to 3 hours
of use.
Storing
If the chain saw is to be stored for a longer period of
time, clean chain and chain bar.
Store in a secure, dry place out of the reach of
children. do not place other objects on the chain
saw. to prevent leakage ensure machine is left in a
horizontal position (oil tank cap 4 uppermost). when
storing machine in original packaging the oil tank
must be completely emptied.
