TWIGA FLEX
10
Definitions of Exclusion Zones
Risk Assessment
Before starting to work near OHPLs you should always assess the risks. The
following points should be observed;
Know
the risks of contacting OHPLs and the risk of flashover.
Find out
the maximum height and maximum vertical reach of your machine.
Find out
the location and route of all Power Lines within the work area.
Find out
the operating voltage of all Power Lines within the work area.
Contact
the local Distribution Network Operator (DNO) who will be able to advise
you on the operating voltage, safe minimum clearance distance for working and
additional precautions required.
Never
attempt
operate the machine in an exclusion zones.
Always
work with extreme caution and plan your work ahead to avoid high risk
areas.
If doubt exists
do not work in the area
– never risk the safety of yourself or others.
Emergency Action for Accidents Involving Electricity
•
Never touch an overhead line - even if it has been brought down by machinery, or
has fallen. Never assume lines are dead.
•
When a machine is in contact with an overhead line, electrocution is possible if
anyone touches both the machine and the ground. Stay in the machine and lower
any raised parts in contact or drive the machine out of the lines if you can.
•
If you need to get out to summon help or because of fire, jump out as far as you
can without touching any wires or the machine - keep upright and away.
•
Get the electricity company to disconnect the supply. Even if the line appears
dead, do not touch it - automatic switching may reconnect the power.
Further information and leaflets on this and other agricultural safety subjects
are available on the ‘Health & Safety Executive’ website at the following
address:
www.hse.gov.uk/pubns/agindex.htm
