TWIGA FLEX
22
Removing From The Tractor
The following steps
MUST
be followed in exactly the same order in which they
appear, with removal of the top link being the last action before driving the tractor
away.
Do not attempt to operate machine controls through the rear cab window whilst
standing on or amongst the linkage.
1. Select a level firm site such as a concreted surface.
2. Fit parking stands. Place the flail head on the ground approximately
1m out from machine main assembly, to the rear.
3. Ensure head float is discharged and turned off.
4. The arms must be slewed back into transport position and the locking
pin fitted to slew post. (Fig. 1)
5. Disengage PTO.
6. Slightly raise the lower lift arms with great care to enable the stabiliser
locking pins to be removed.
7. Lower all weight securely onto parking stands (Fig.2).
8. Stop engine; ensure all weight is off the tractor and machine hydraulics.
9. Remove stabiliser bars, lower link pins, PTO shaft and control unit from
the cab.
10. Remove top link.
11.
Slowly drive tractor away.
Subsequent Attachment to a Different Tractor
Follow the steps for “Attaching your Machine to the Tractor”.
Fig. 1
Fig. 2
Fig. 1
