2
SETUP
WARNING! Always turn off the RE when not in use and/or when working on the bicycle.
A
B
4
2
1
3
Power off your TURBO SL bicycle (fig. 1).
Install the cage on the bicycle according to the instructions supplied with the bottle cage. Only use the recommended bottle cage (Zee Cage II) for the RE.
Insert the power cable plug with the rounded cover (fig. 2 A) into the upper port of the RE. Looking from the side, ensure the connector sits flush on the RE, and the two o-rings are fully
inserted into the port.
Clip the cable into the channel located in the RE housing (fig. 2 B).
Install the RE in the bottle cage (fig. 3).
Secure the RE into the bottle cage using the supplied Specialized band (fig. 4).
A
B
7
5
6
Locate the charge port on the non-drive-side of the frame near the bottom bracket (fig. 5).
Open the charge port lid (fig. 5-6 ) and insert the RE plug into the charge port (fig. 7 A).
Once the plug is seated correctly, twist the lever on the connector clockwise until fully engaged to lock the cable in place (fig. 7 B).
To verify the RE is successfully connected to the system, check that the green charge level LED lights appear on the TCU (fig 11).
WARNING!: When riding with an RE installed, ensure both ends of the cable are properly connected to the ports as described above. A loose cable can cause damage to your
bicycle and the RE can become an obstruction which may cause you to lose control and fall.
WARNING: Always use the specified bottle cage when using the RE, and always check it before each use for possible damage. Use of an unspecified bottle cage can cause
the RE to come loose and fall out, which can result in injury.
CAUTION: Dirt buildup can result in the RE plug’s locking lever being difficult to rotate. Clean the RE plug regularly with a damp cloth and allow the plug to dry before use.
CAUTION: When installing the bottle cage make sure to use the supplied screws. Longer screw heads can cause damage to the RE.
