BETRIEBSANLEITUNG
13
9
Störungen, Ursachen und Beseitigung
Störung
Ursache
Beseitigung
Die Pumpe verursacht Geräu-
sche
Beim Betrieb mit niedrigeren
Ansaugdrücken als angege-
ben (auch bei geschlossener
Saugseite) oder bei zu hohem
Dampfanteil im Fördermedium
entsteht ein knarrendes
Geräusch
Abhilfe siehe 7.2
Frischflüssigkeitsmenge F zu
groß
Flüssigkeit im Fördermedium D:
Regulierventilstellung prüfen, nach-
regulieren
Die Pumpe erreicht nicht das
Auslegungsvakuum
(Druck/Volumen)
Anlage undicht
Absperrvorrichtung falsch geöffnet:
Anlage prüfen, Leckstellen abdich-
ten
Betriebsflüssigkeitsmenge zu
hoch
Die Kennlinien beziehen sich auf
Wasser mit 15° C als Ringflüssig-
keit, so dass bei höherer Betriebs-
temperatur eine Minderung des
Vakuums und ebenso des Saug-
vermögens eintritt. Temperatur der
Flüssigkeit durch geeignete Maß-
nahmen senken.
Gas- bzw. Flüssigkeitskanäle
verschlossen
Pumpe zerlegen und besonders die
Kanäle reinigen
Gleitringdichtung ist undicht
Gleitringdichtung auswechseln
Ablaufflüssigkeitsmenge A zu
klein
Flüssigkeitsablaufleitung auf Durch-
gang prüfen
Die Pumpe klemmt
Korrosion zwischen Rotor und
Gehäuse
durch rostlösende Mittel beseitigen
Eis in der Pumpe
Ringflüssigkeit erstarrt: vorsichtig
erwärmen, auftauen
Verunreinigungen, Fremdkör-
per in der Pumpe
Pumpe zerlegen und reinigen
Leistungsaufnahme der
Pumpe zu hoch
Betriebsflüssigkeitsmenge zu
groß
Regulierventile nachregeln
Dichte bzw. Viskosität der
Flüssigkeit zu hoch
Die Leistungsangaben beziehen
sich auf Wasser
(1000 kg/m
3
, 1 mm
2
l
s
),
größere
Dichte bzw. Viskosität bedingen eine
höhere Wellenleistung. Andere
Betriebsflüssigkeiten oder größere
Motorleistung vorsehen
Laufrad reibt an Steuerschei-
be
Pumpe zerlegen, reinigen und
richtiges Spiel einstellen