O
O
N
N
S
S
I
I
P
P
O
O
2
2
D
D
4
4
O
O
w
w
n
n
e
e
r
r
’
’
s
s
M
M
a
a
n
n
u
u
a
a
l
l
Rev.1.3 (June,2013)
12
2.4. Functional Description
DC 12V, 2A: Power input for supplying 12V DC power.
Caution:
If ONSIP O2D4 is powered by PoE, do not plug in DC Jack with active DC
power into DC power connector.
MIC/LINE IN
Connect external audio source or microphone.
Line Out
Connect speakers with built in amplifier. Audio from remote site is output through Line out in bi-directional
audio mode.
100Base-T
100Mbps Ethernet connector (RJ-45) with PoE standard (802.3af). 2 LEDs on the Ethernet connector
show the status of ONSIP O2D4 as the following:
-
Status LED (Dual Color - Red/Green)
: It will be lit in green or red depending on the status.
Green: Green color indicates that the camera is in normal operation mode. Continuous green
indicates that data transmission is possible. Blinking green means that someone is
connected to ONSIP O2D4.
Red: Continuous or blinking red indicates that hardware is in abnormal condition.
- LINK/LAN LED (Orange)
It will be lit with orange color when network cable is connected correctly. Blinking orange color indicates
normal data transmission. Off state indicates that there is trouble with the network connection.
Alarm In/Out and Audio In/Out
Used for connecting alarm sensor, alarm annunciation device, microphone and speaker to ONSIP O2D4.
Red/Green LED will be lit with red momentarily and it will be lit with green after a while when
power is applied into ONSIP O2D4