KolibriSensor
V2.0 | June 17, 2014
Parameter
Value
Noise Floor (when used with a
KolibriSensor)
< 1.0 fm/√Hz
Max. Oscillation Amplitude
7 nm
Table 1: KolibriPreamp specifications
4.2
Attenuators
The Starter Kit is supplied with two 20 dB attenuators. These are connected in series between
the output of the Nanonis Oscillation Controller and the Excitation input of the test stage. The
attenuators protect the KolibriSensor from excessive drive levels and improve the signal to
noise ratio of the excitation signal.
4.3
Receptor Pin Assignment
Figure 13 shows the pin assignment of the KolibriReceptor on the test stage. The signal pins are
isolated against ground.
Figure 13: Pin assignment of the KolibriReceptor
12
