1
KolibriSensor
V2.0 | June 17, 2014
Chapter 1 – Introduction
Welcome to the user manual for the SPECS KolibriSensor Starter Kit.
The Starter Kit enables evaluation of a KolibriSensor without the need to mount it in a micro-
scope. The KolibriSensor has proven its qualities in the SPECS Aarhus SPM 150 and the SPECS
JT-SPM as well as being suited for use in custom microscopes. By fitting a KolibriSensor into the
test stage, you can investigate the response of the KolibriSensor under a variety of exper-
imental conditions (cable length, preamp, etc).
1.1
Information
This manual contains the information necessary for operating the Starter Kit in a basic con-
figuration. For more information about the KolibriSensor, particularly when using it in a micro-
scope for SPM measurements, please refer to:
Nanonis software Online Help (press F1 for context sensitive help of the currently open
panel).
SPECS SPM 150 manual.
For further advice and assistance, please also contact SPECS support:
Tel.
+49 30 46 78 24-0
email: support@specs.com
If you need to return this SPECS product for repair, service or upgrade, please first contact
SPECS support. We will provide you with an RMA as well as details for correct packaging and
shipment of the instrument. This will ensure safe transportation and speedy processing.
1.2
Safety
The document "Safety Instructions" is contained with this instrument. This contains important
warnings and procedures that you should adopt when using SPECS equipment.
1.3
Environmental Operating Conditions
The equipment must be installed in a dry, dust free laboratory. The following conditions are
required for operation.
Temperature (normal system operation):
absolute limit range: 15–30 °C (60–85 °F)
recommended range: 20–25 °C (68–77 °F)
Relative humidity:
