SC5 Signal Conversion
Performance Measurements
•
69
Noise 0.1 Hz – 10 Hz
The low-frequency noise of the SC5 fast analog output is measured with the same set-up as used for AO1 – AO8.
The following settings were used for the measurement:
SC5
DMM
Measured output:
FAST AO
Mode of operation: Digitizer, AC volts
Output amplitude: 0 V
Range:
100 mV
Sample rate:
100 S/s
Resolution:
22 bit
The following graph shows a typical trace for the output noise in the 0.1 to 10 Hz range:
Figure 52: SC5 fast output noise 0.1 - 10 Hz.
Typical RMS and peak-to-peak noise values in the 0.1 Hz to 10 Hz range are listed below:
RMS noise p-p noise
< 590 nV
< 2.3 µV
Noise 10 Hz – 300 kHz
The noise of the fast analog output of the SC5 fast output above 10 Hz is measured with the same set-up as used for
AO1 –AO8. The upper frequency limit is given by the analog bandwidth of the multimeter.
The following settings were used for the measurement:
0
2
4
6
8
10
1
3
5
7
9
Time [s]
O
ut
pu
tN
oi
se
Vo
lta
ge
[n
V]
2000
1600
1200
800
400
0
-400
-800
-1200
-1600
-2000
Output range: ±10 V
Summary of Contents for Nanonis SC5
