Chapter 3 Front Panel Control
2. Press the Setup button repeatedly until the display shows Deflect X or Deflect Y, depending which you want to
set.
Figure 23: Setting Deflect X and Deflect Y
3. Press the Modify button. The LED above the Modify button will light and flashing triangles will appear below the
parameter value.
4. Enter a new value using one of the following methods:
■
Turn the jog shuttle until you reach the desired value.
■
Press and hold Num while entering the desired number using the numerical keys. The numbers are entered
from right to left.
5. Press Modify to accept the value. This leaves the setting mode; the jog shuttle and numerical keys are inactive.
3.5.10 HPIB Address
You can set the address used for the IEEE-488 connection with the HPIB Addr parameter. The address value is a number
between 0–31.
To change the HPIB address:
1. Press and hold Num, then press Operate to set the unit into Off mode.
2. Press the Setup button repeatedly until the display shows HPIB Addr.
Figure 24: Setting the HPIB address
3. Press the Modify button. The LED above the Modify button will light and flashing triangles will appear below the
parameter value.
4. Enter a new value using one of the following methods:
PU IQE 12/383.0
April 26, 2013
27
