Tethering the stylus
Attach the stylus to the device to prevent accidentally dropping the stylus. The stylus is supplied with
one end of the tether cord pre-looped to the stylus. You can attach the stylus to the left or the right side
of the device. To tether the stylus to the device:
1. Take the loose end of the tether cord and
push it through the tether point.
2. Feed the stylus through the loop and pull
tight.
3. Place the stylus in the stylus dock (shown
top left in the image below) to store it when
not in use.
Installing a screen protector
The Ranger 5 data collector is fitted with a mechanically
strengthened glass touchscreen which is highly resistant
to abrasion and impact damage. However to ensure
maximum protection, it is recommended that you use a
Spectra Geospatial-approved glass Ranger 5 data collector screen protector.
To install a screen protector:
1.
Place the device on a clean, flat surface.
Make sure your hands are clean.
2.
Clean the touchscreen with the supplied
alcohol wipe.
Spectra Geospatial Ranger 5 Data Collector User Guide |
28
Setting up the device
