35
Normal Operation and Fresh Water Flush
If the system has been pickled or stored, use the New System Startup procedure on page 31.
You should fresh water flush your watermaker after every use. Remember that you need to
run the system almost a half hour to make enough fresh water for one flush. You may notice
that the system output is higher when charging your batteries, as the watermaker is voltage
sensitive.
1. Check to see that the inlet and brine discharge seacocks are open.
2. Push Auto Run one or more times. The machine will run for one hour for each time the
button is pushed, then shut off and automatically do a fresh water flush.
3. Run the system until you have filled your tank or have made enough to meet your require-
ments for several days.
4. After the system fresh water flushes and shuts down it will enter the Auto Store mode,
which will flush the system at programmed intervals. See the next page.
5. You may stop the system at any time with the Stop button. If the Stop button is pressed
during operation, the system will not flush itself or go into Auto Store mode.
Auto Store mode: The timer counts down the hours until the next Fresh Water Flush.
Summary of Contents for Ventura 150T MPC
