English
5
• Once the receiver has been initialized, you can remove the
SD card and put that card away in a safe place.
Warning!
For some reason, you may need to use
>
Settings
>
System
>
Reset to factory default
to reset the receiver to its
default settings.
Be aware this will delete the applications
you installed from the SD card
.
So please insert the SD card
before you reset to factory settings
, This will automatically re-
start the installation of the applications once the reset
sequence is complete.
Adjusting
Backlight Level
The screen backlight may be adjusted to match the ambient
light for optimized visibility. You don’t need the same level of
screen backlight in dark areas than in hot sun.
•
On the Home screen, tap successively
,
Settings
,
System
and
Brightness
.
•
Drag the cursor to the right or left to set the screen
backlight to the desired level (between 0 and 10). The
resulting brightness is obtained when you release the
cursor.
•
Tap
OK
to save your setting.
•
Tap
to return to the Home screen.
Setting Backlight
Idle Time
One way of saving the battery is to avoid those periods of time
during which the screen backlight is unnecessarily on.
As the receiver automatically counts the time during which
neither the keypad nor the touch screen is active, you can set
the receiver to turn off the backlight automatically after a
certain idle time.
•
On the Home screen, tap successively
,
Settings
,
System
and
Backlight
.
•
Choose the idle time before the backlight is turned off
(10 seconds, 30 seconds or 1 to 5 minutes). For
maximum power saving, you may clear the option that re-
activates the screen backlight on touching the screen or
pressing a key.
Different settings may be made for these two parameters
depending on the power source used (battery or external).
•
Tap
OK
to save the settings.
•
Tap
to return to the Home screen
