English
13
The top view of the docking station shows the slot
[19]
in
which to insert the receiver from above the docking station.
At the bottom of the slot is the 16-contact connector
[20]
.
When resting on the docking station, the receiver is
automatically powered from the AC adapter (if connected)
and the charging status of its internal battery tested.
Rear View
The following elements can be found at the rear of the
docking station:
•
Back slot
[21]
for charging a second battery
•
Charging indicator
[22]
for back slot:
– Steady red: Battery charging in progress
– Steady green: Battery fully charged
– Off: No battery connected
– Blinking red, every second: Temperature inside battery
exceeds upper limit. Charging suspended until
temperature is back to normal. If persisting, remove
the battery and resume charging later. If this occurs
several times with the same battery, consider changing
the battery. Dispose of the battery according to
regulations.
•
Mini USB connector
[23]
: Use this connector only to let
the receiver communicate with your computer through
Microsoft ActiveSync (USB “Device”).
•
USB connector
[24]
, Use this connector to plug a USB
key (USB “Host”, mass storage only).
•
RS232 SubD 9-C connector
[25]
: Use this port to connect
the receiver to a computer or external device.
•
Power input
[26]
. Connect the output of the AC adapter to
this input.
[21]
[22]
[23] [24]
[25]
[26]
