Spectracom Corporation
Model 9289
NetClock/NTP Network Time Provider Instruction Manual
3-5
3.2
Initial Network Configuration
NOTE:
The IP address assignment in this configuration may be performed even if your
network has a DHCP server. There may be times when you do not wish DHCP to
assign the IP address for the NetClock.
To configure a NetClock without DHCP or to configure a NetClock that has not been assigned
an IP address (or one that has been assigned an IP address that is not visible because the unit
does not have the optional Front Panel Display), use the provided serial cable to connect a PC
or laptop computer to the serial setup port on the back of the NetClock. After making this
connection, use a terminal program (such as HyperTerminal) to log into the NetClock as an
administrator. Use the Command Line Interface (CLI) in the terminal program to configure initial
values and determine the NetClock’s network address.
3.2.1 Using HyperTerminal to Connect to the Netclock
Microsoft’s HyperTerminal program is typically located under
Accessories – Communications
in
the Windows PC Start Menu. (Most terminal programs can be used to connect to the NetClock.
it is not necessary to use HyperTerminal specifically.) Establish a new connection using the
serial port to which you have connected the NetClock (typically COM1).
Figure 3-5: Establishing a New Terminal Connection
Summary of Contents for 9289
Page 18: ...Model 9289 Spectracom Corporation NetClock NTP Network Time Provider Instruction Manual 1 8...
Page 36: ...Model 9289 Spectracom Corporation NetClock NTP Network Time Provider Instruction Manual 2 18...
Page 154: ...Model 9289 Spectracom Corporation NetClock NTP Network Time Provider Instruction Manual 3 118...
