2.
Move the reference which has “NTP” in the
Time
column and “NTP” in the
1PPS
column
to the second place in the table, with a
Priority
value of 2. Click the
Enabled
checkbox.
3.
For all other references, uncheck the
Enabled
checkbox, so that they are all disabled.
Since both of these references are
default
references, no additional references need to be
added to the
Reference Priority
table.
Example 3 – NTP input as the only available input (“NTP Stratum 2 operation”)
In this use case, the objective is to have NTP provided by another NTP server as the only avail
able reference input, i.e. the unit to be configured is operated as a Stratum 2 server. For more
information, see "Configuring "NTP Stratum Synchronization"" on page 104.
Step-by-step procedure:
1.
Move the reference which has “NTP” in the
Time
column and “NTP” in the
1PPS
column
to the top of the table, with a
Priority
value of 1. Click the
Enabled
checkbox.
2.
For all other references, uncheck the
Enabled
checkbox, so that they are all disabled.
3.
Configure the NTP Service as described under "Configuring "NTP Stratum Syn
chronization"" on page 104.
Note:
When selecting NTP as an input reference, do not select another reference
(such as GNSS, IRIG, etc.) to work with NTP as a reference. NTP should always
be selected as both the Time and 1PPS input when it is desired to use NTP as an
input reference.
Example 4 – Time set manually by the User. Other references may or may not be
available
Note:
In order for a manually set time to be considered valid and used to syn
chronize NetClock, a “User” needs to be created and enabled in the Reference
Priority table.
"The "User/User" Reference" on page 167
.
In this use case, the objective is to use a hand-set time, in combination with NetClock's oscillator
as a 1PPS source as valid references.
Step-by-step procedure:
1.
If necessary (see NOTE above), create a “User.”
2.
Move the reference which has “User 0” in the
Time
column and “User 0” in the
1PPS
170
CHAPTER
3
•
NetClock User Reference Guide
Rev.
16
3.3 Managing Input References
Summary of Contents for NetClock 9400 Series
