Auto Sync Control
: In the event jamming or spoofing is detected, NetClock will emit a
Major Alarm AND it will go into Holdover mode.
To configure these settings:
1.
Navigate to
MONITORING > BroadShield
.
2.
In the
BroadShield Service
panel on the left, configure the desired setting:
Note:
Turning BroadShield
OFF
and Auto Sync Control
ON
is an invalid
setting and will cause a "
Failed to connect to the unit...
" error.
3.
In the
BroadShield Web UI
on the right, navigate to
SETTINGS > ALGORITHMS
, and
ensure that
Jamming
and/or
Spoofing
detection are enabled.
Configuring BroadShield
To configure BroadShield:
1.
Navigate to
MONITORING > BroadShield
. (If you cannot see the
MONITORING
button
in the Primary Navigation Bar of the
HOME
screen, this license is not present.) The
embedded Broadshield Web UI will open.
2.
Click
SETTINGS
to open the following sub-menus:
BROADSIGHT
BroadSight is a service that allows collection of data from multiple BroadShield units and
provides a dashboard view of the data.
Note:
BroadSight for NetClock is currently not supported.
176
CHAPTER
3
•
NetClock User Reference Guide
Rev.
16
3.3 Managing Input References
Summary of Contents for NetClock 9400 Series
