Note:
Whether or not notifications are enabled/disabled for a given event, the
occurrence of the event is always logged.
All available NetClock events that can generate a notification to be sent are located under dif
ferent tabs in the Notification Events panel:
Timing
,
GPS
, and
System
.
The NetClock Events that can automatically trigger a notification are listed in the
Event
column.
It is possible to:
Mask the alarm generation for specific events (prevent the alarm)
Enable “SNMP” (to send out an SNMP trap)
Send an email to the address specified in the corresponding “Email Address” column.
4.2.1
Configuring Notifications
To configure Notifications:
1.
Navigate to
MANAGEMENT > OTHER: Notifications
. The
Notifications
screen will dis
play:
It is divided into two panels:
The
Actions
panel, featuring:
The
SNMP Setup
button: See "SNMP" on page 84.
The
Email Setup
button: Configure NetClock's interface settings for
Exchange email servers and Gmail.
For more information on this subject, see the Spectracom Technical Note
Email Notification Setup
.
228
CHAPTER
4
•
NetClock User Reference Guide
Rev.
16
4.2 Notifications
Summary of Contents for NetClock 9400 Series
