Note:
Each event can be configured with the desired email address that is
specific to just that one event only. Note that only one email address can
be specified in each Email Address field.
For each event choose the notification you want and an email address – if any – to
which you want the notification to be sent. For more information, see "SNMP" on
page 84 and "Setting Up Email Notifications" on page 233.
For each event, only the notification options available can be configured. For example,
a mask alarm can be set for an In-Sync event, and a Not-in-Sync event, but not for an In-
Holdover event.
4.2.2
Notification Event Types
The following types of events can be used to trigger notifications:
4.2.2.1
Timing Tab: Events
In Sync
Not In Sync
In Holdover
No Longer in Holdover
Frequency Error
Frequency Error Cleared
1PPS Not In Specification
1PPS Restored to Specification
Oscillator Alarm
Oscillator Alarm Cleared
Reference Change (Cleared)
Reference Change
4.2.2.2
GPS Tab: Events
Too Few GPS Sat, Minor Alarm
Too Few GPS Sat, Minor, Cleared
Too Few GPS Sat, Major Alarm
Too Few GPS Sat, Major, Cleared
230
CHAPTER
4
•
NetClock User Reference Guide
Rev.
16
4.2 Notifications
Summary of Contents for NetClock 9400 Series
