Main tab settings
Domain Number
: Sets the current PTP Domain Number, as defined in IEEE Std 1588-
2008 Section 7.1
Clock Mode
: PTP has two ways to transmit the initial T1 timestamp of the Sync packet
transmission from the Master to the Slave:
One-Step
Master: The Sync packet is timestamped, then the timestamp is inserted
into the Sync packet in real-time, as it is transmitted.
Two-Step Master
: The Sync packet is timestamped, but the timestamp value in the
Sync packet is ignored. The actual T1 value is transmitted in a "Follow-Up" packet
after the Sync packet.
Note:
PTP Masters must select one mode or the other to operate in.
The default mode is one-step.
Enable DHCP
: This is a checkbox to enable or disable the delivery of IP addresses from
a DHCP Server. The default setting is enabled (the box is checked).
Static IP Address
: When a DHCP server is not requested or is requested but not avail
able, the PTP Module will use this IP address. In the format “#.#.#.#” with no leading zer
oes or spaces, where each ‘#’ is a decimal integer from the range [0,255].
Network Mask
: When a DHCP server is not requested or is requested but not available,
the PTP Module will use this Network Mask. In the format “#.#.#.#” with no leading zer
oes or spaces, where each ‘#’ is a decimal integer from the range [0,255].
Default Gateway
: When a DHCP server is not requested or is requested but not avail
able, the PTP Module will use this Default Gateway. In the format “#.#.#.#” with no lead
ing zeroes or spaces, where each ‘#’ is a decimal integer from the range [0,255].
Contract tab settings
Note:
The settings under this tab only apply to Unicast mode.
[Default settings in parenthesis]
Min Sync Interval
: The
minimum
value of Sync interval granted by the Master Clock. In
packets per second. [128 Per Second]
Max Sync Duration
: The maximum value of Sync interval granted by the Master Clock.
In seconds. [10000]
368
NetClock User Reference Guide
APPENDIX
Summary of Contents for NetClock 9400 Series
