2.
Configure your terminal emulation program, using the following settings:
Port
: COM1
Bits per second
: 9600
Data bits
: 8
Parity
: None
Stop bits
: 1
Flow control
: None
3.
Depending on which network protocol you are using (SSH, Telnet), you will need to
enter authentication upon establishment of the connection either in a separate authen
tication window, or the Terminal window: The default user name is
spadmin
, and the
password
admin123
.
4.
Using the Terminal window, you can now submit commands; see "CLI Commands"
below for a list of commands.
5.3.2
CLI Commands
NetClock features a suite of command-line interface (CLI) commands that can be used to con
figure parameters and retrieve status information or log files via a remote connection, using the
telnet
or
ssh
(if enabled) protocol.
This section includes a list of some of the supported commands.
382
NetClock User Reference Guide
APPENDIX
Summary of Contents for NetClock 9400 Series
