Rack mounting requirements:
The maximum
ambient operating temperature
must be observed. See for the operating
temperature range specified for the type of oscillator installed in your NetClock unit.
If the NetClock unit is to be installed in a closed rack, or a rack with large amounts of
other equipment, a
rack cooling fan
or fans should be part of the rack mount install
ation.
Installation of the unit in a rack should be such that the amount of
air flow
required for
safe operation of the equipment is not compromised.
Follow the mounting directions described below to
prevent uneven mechanical loading
,
possibly resulting in a hazardous condition.
Do not overload power supply circuits
. Use only supply circuits with adequate overload
protection. For power requirements, see "Input Power" on page 19.
Reliable
grounding
of rack-mounted equipment must be maintained. Particular attention
must be given to supply connections other than direct connections to the branch circuit
(e.g., use of power strips).
The NetClock
ancillary kit
contains the following parts needed for rack mounting:
2 each 1165-1000-0714 rack mounting brackets
2 each MP09-0003-0030 equipment rack handles
4 each H020-0832-0406 #8-32 flat head Phillips screws
6 each HM20R-04R7-0010 M4 flat head Phillips screws
The following
customer supplied items
are also needed:
4 each #10-32 pan head rack mount screws
1 each #2 Phillips head screwdriver
1 each 3/32" straight screwdriver
To rack mount the NetClock unit:
1.
Attach an MP09-0003-0030 equipment rack handle to the front of each 1165-1000-
0714 rack mounting bracket, using the holes nearest the right angle bend of the 1165-
1000-0714 rack mounting bracket, with the #2 size Phillips screwdriver, using 2 each of
the H020-0832-0406 #8-32 flat head Phillips screws.
2.
Attach the 1165-1000-0714 rack mount brackets to the sides of the NetClock with the
rack mounts ears facing outward, aligned with the front edge of the NetClock front
panel. Use the #2 Phillips screwdrivers, using 3 each of the HM20R-04R7-0010 M4 flat
head Phillips screws.
3.
Secure the rack mount brackets to the rack using the #10-32 rack mount screws and #2
Phillips head screwdriver, 2 each per side of the rack.
2.5 Mounting the Unit
CHAPTER
2
•
NetClock User Reference Guide
Rev.
16
35
Summary of Contents for NetClock 9400 Series
