DB9M serial cable. The VelaSync serial port operates at 9600 baud, 8 data bits, no par-
ity, 1 stop bit.
The serial port can be used to make configuration changes (such as the network set-
tings), retrieve operational data (e.g., GNSS receiver information) and log files, or to per-
form operations such as resetting the admin password.
The serial port is account and password protected. You can log in via the serial port
using the same user names and passwords as would be used to log in to the VelaSync
Web UI. Users with
administrative
permissions can perform all available commands.
Users with
user
permissions only can perform “get” commands that retrieve data, but
cannot perform any “set” commands or change/reset any passwords.
To configure an IP address via the serial port:
1.
Connect a serial cable to a PC running PuTTY, Tera Term, or HyperTerminal, and
to your VelaSync. For detailed information on the serial port connection, see
ting up a Terminal Emulator" on page 216
2.
Login to VelaSync with a user account that has “admin” group rights, such as the
default
spadmin
account (the default password is
admin123
).
3.
Disable DHCP, type:
dhcp4set 0 off
<Enter>.
Note:
For a list of CLI commands, type
helpcli
, or see
.
4.
Configure the IP address and subnet mask, type:
ip4set 0 x.x.x.x y.y.y.y
<Enter>
(where
0
is the desired interface, “
x.x.x.x
” is the desired IP address for
VelaSync, and “
y.y.y.y
” is the full subnet mask for the network (For a list
of subnet mask values, see
"Subnet Mask Values" on the facing page
.)
5.
Configure the gateway by typing
gw4set 0 z.z.z.z
<Enter>
(where
0
indicates which interface routing table to add the default gateway for,
and “
z.z.z.z
” is the default gateway address).
6.
Remove the serial cable, connect VelaSync to the network, and access the Web
UI, using the newly configured IP address. (For assistance, see
).
The remainder of the configuration settings will be performed via the Web UI (accessed
via an external workstation with a web browser such as Firefox
®
or Chrome
®
).
34
CHAPTER
2
•
VelaSync User's Manual Rev. 3
2.7 Configuring IP Address(es)
Summary of Contents for VelaSync 1225
