preserved.
Caution:
Resetting the GNSS receiver may become necessary in the
rare event of internal communication issues, and is typically ONLY
required if
Spectracom Technical Support
advises you to execute this
command.
Note that resetting the GNSS receiver is not the same as
To reset the GNSS Receiver:
1.
Navigate to
Interfaces > References: GNSS Reference
2.
Click on the GEAR button next to the GNSS Reference. The
GNSS 0
window
opens:
3.
Locate the
Reset Receiver
box, check it, and click Submit.
3.3.3.8 Deleting the GNSS Receiver Position
The VelaSync timing system requires the exact geographic position in order to calculate
the exact system time from the GNSS signal.
The
Delete Position
command deletes the GNSS antenna position data that is stored in
the non-volatile memory of the GNSS receiver.
The deletion of the position data will automatically initiate a new
GNSS self survey
,
provided:
a GNSS antenna is connected to VelaSync
the GNSS receiver can track at least four satellites continuously
and the GNSS receiver it is configured to operate in
Standard Mode
.
The objective of the
GNSS Survey
is to re-discover the current antenna position.
136
CHAPTER
3
•
VelaSync User's Manual Rev. 3
3.3 Managing References
Summary of Contents for VelaSync 1225
