For more information on this subject, see the Spectracom Technical
Note
The
Events
panel, offering three tabs:
Timing
: Events for Sync Status and Holdover, Frequency error, Input
references and the internal oscillator.
GPS
: Events related to the GNSS receiver, including antenna cabling,
tracking less than the minimum number of satellites and GNSS
receiver faults.
Systems
: Events related to the system operation, including minor
and major alarms being asserted, reboot, timing system errors and
option cards.
2.
In the
Events
panel, choose the
Timing
,
GPS
or
System
tab. Configure your Noti-
fications (see below), and click Submit.
The columns under each tab are:
Event
—This is the event that will trigger the notification. The events under
each tab will vary according to context.
Mask Alarm
—Check here to enable an alarm mask. Enabling an alarm mask
for a given notification will prevent that notification from generating an
alarm condition. Other notifications for that event and logging of the event
will still occur.
SNMP Trap
—Check here to configure the event to trigger an SNMP Trap.
—Check here to configure the event to trigger an email notification.
168
CHAPTER
4
•
VelaSync User's Manual Rev. 3
4.4 Notifications
Summary of Contents for VelaSync 1225
