Figure 2-2:
Optional inner rails
Installing the outer rail to the rack:
1.
Measure the distance from the front rail to the rear rail of the rack. Attach a
short bracket
to the front side of each of the outer rails, and a
long bracket
to
the rear side of each outer rail.
2.
Adjust both the short, and the long brackets to the proper distance so that the
rails fit snugly into the rack. Secure the short bracket to the front side of the
outer rail with
two screws
, and the long bracket to the rear side of the outer rail
with
three screws
.
Installing the server into the rack:
Once all the rails have been installed to the VelaSync chassis and the rack, the VelaSync
unit can be installed into the rack.
Caution:
The unit weighs approximately 24 lbs (11 kg). Depending on
your chosen installation location, it may be advisable to lift the unit
with two persons.
3.
Line up the rear of the inner rails at the chassis with the front of the outer rails at
the rack. Slide the server chassis into the rack, keeping the pressure even on
2.4 Rack Installation
CHAPTER
2
•
VelaSync User's Manual Rev. 3
27
Summary of Contents for VelaSync 1225
