111 Highland Drive
–
Putnam, CT 06260
Phone 860-928-5834
–
Fax 860-928-2676
Operation
Front
Back
Component
Description
Power terminal
input
Connects power cable to provide voltage to our deuterium and high power tungsten-
halogen hybrid light source. One main power supply provides the input voltages on
both lamps.
Power switch
There are three on/off power switches on the light source. One is the main power
switch that is located on the front side. The other two are for the deuterium and the
tungsten-halogen, which is located on the backside.
Note
: It takes ~20-30 seconds to warm up the deuterium power supply so the
deuterium light doesn’t come on immediately when the
deuterium power switch turns
on. If the tungsten-halogen is on while turning on the deuterium, the tungsten-halogen
light can blink several times.
Fuse
Contains the fuse to protect the unit against overload.
Fuse type:
For main 24V power supply: 5A/250V
For deuterium relay power supply: 2A/250V
Cooling fan
Cools the interior of the light source housing.
Note
: Do not look at the light beam through this fan, especially when the deuterium is
on.
Output
SP can provide SMA905 or FC. SMA is the default connector.
The tungsten-halogen light is much stronger than the deuterium light in general. The
balanced output version, ASBN-DW-F-BAL, will be adjusted the tungsten-halogen
output signal at SP based on SP’s CCD spectrometer for the 200
-1100nm range.
Main Power
Switch
Fiber coupling output. SP can provide
SMA905 or FC type connector.
Cooling Fan
Power
terminal
Input & Fuse
D2 & Tungsten
Power Switches
