14215700-IG, Edition 15.0
May 2020, Original document
192
3. Click
Save
.
4. Click
Reboot base station
.
Automatic Configuration of Radio Synchronization
For a coverage area with up to 256 base stations, it is possible to perform automatic radio syn-
chronization. If more than 256 base stations within the same coverage area, the radio syn-
chronization must be configured manually. For more information, see
Radio Synchronization" on page 189
When using automatic radio synchronization, the system measures and finds the base station with
the highest signal strength (RSSI value) and best signal quality (Q value) to radio synchronize on.
Note:
Automatic configuration of radio synchronization is only supported on systems running
firmware PCS 20B_ or newer. Both KIRK IP Base Stations and Spectralink IP-DECT
Base Stations support automatic configuration of radio synchronization.
A site survey and deployment must have been conducted. For more information about
deployment, see the Synchronization and Deployment Guide.
Be aware, that if using automatic synchronization of base stations, all current base sta-
tion settings will be overwritten.
Automatic configuration of radio synchronization can only be used in a coverage area
with a maximum of 256 base stations and only base stations with sync type
Radio
can be
auto synchronized. More sites can be automatically radio synchronized simultaneously. If
using different sites (with up to 256 base stations on each), the sites must be physically
separated and not share coverage area.
For more information about configuring sites and assigning base stations to a site, see
"Configuring Sites (and Zones)" on page 175
.
Spectralink IP-DECT Server 200/400/6500 and Virtual IP-DECT Server One Installation and Configuration Guide