SpectraLink Corporation
Installation and Administration
NetLink OAI Gateway
•
Allow Telnet Connections
Enter
Y
(yes) to allow connection to the NetLink
OAI Gateway via Telnet; enter
N
(no) if you do not want to allow Telnet
connection.
•
Allow FTP Connections
Yes
/
No
* (MOG 7xx only)
•
DNS server
and
DNS domain
These settings are used to configure Domain
Name services. Consult your system administrator for the correct settings. These
can also be set to DHCP. This will cause the DHCP client in the Gateway to
attempt to automatically get the correct setting from the DHCP server. The
DHCP setting is only valid when the IP address is also acquired using DHCP.
•
WINS servers
These setting are used for Windows Internet Name Services.
Consult your system administrator for the correct settings. These can also be set
to DHCP. This will cause the DHCP client in the gateway to attempt to
automatically get the correct setting from the DHCP server. The DHCP setting
is only valid when the IP address is also acquired using DHCP.
When the name services are set up correctly, the NetLink OAI Gateway
can translate hostnames to IP addresses. When using Telnet, it is also
possible to access the OAI Gateway using its hostname instead of the IP
address.
•
Logging
and
Log server
Logging can be set to
Syslog
or
NONE
. The log server
is the IP address or hostname of the syslog server on the network. The gateway
will output syslog format diagnostic messages. This is usually not needed.
•
SNTP server
Can be set to a hostname, IP address or
NONE
. The SNTP server
is a simple network time server. The OAI Gateway will get the current date and
time from the SNTP server. It will tag syslog messages with the date.
•
IGMP Enabled
Yes
/
No
.
IGMP
is the Internet Group Routing Protocol.
IGMP
Enabled
allows the OAI Gateway to join multicast groups. If the network switch
connected to the OAI Gateway requires IGMP for multicast traffic to be
forwarded this should be enabled.
•
Maintenance Lock
The system automatically sets this option to
Yes
after
certain maintenance activities that require reset. These are indicated in this list
with an arrow bullet.
Maintenance Lock
prevents any new calls from starting. Note
that the administrator cannot change this option. It is automatically set by the
system. Reset the system at exit to clear
Maintenance Lock
.
Press Esc to return to the
NetLink OAI System
menu.
PN: 72-0078-07-B.doc
Page 20
