SpectraLink Corporation
NetLink e340 Wireless Telephone User Guide
Part Number: 72-1001-01-B.doc
Page 14
Removing and Replacing the Battery Pack on the Wireless Telephone
Removing the Battery
Pack
To remove the Battery Pack, press down on the latch on
the Battery Pack on the back of the Wireless Telephone.
The Battery Pack releases outward.
Replacing the Battery
Pack
To replace the Battery Pack, slide the lip of the Battery
Pack into the bottom of the cavity. Push the top of the
Battery Pack until it snaps into place. You should not have
to force it against the Wireless Telephone.
Changing the Battery
Pack while in a call
The Battery Pack may be changed while the call is still in
progress. If you are using the NetLink Telephony Gateway
in your telephone system, do not press
Power Off/End
Call
on the Wireless Telephone. Quickly remove the
discharged Battery Pack and replace with a charged
Battery Pack, then press
Power On/Start Call
to turn the
Wireless Telephone back on. Press
Power On/Start Call
again to
resume the call in progress. Users of IP telephony
interfaces not requiring the NetLink Telephony Gateway
should Park a call prior to changing the Battery Pack
during an active call. The call should then be retrieved
after the Battery Pack is replaced to rejoin the
conversation. Check with the switch administrator for
instruction on how to perform this or a similar process on
your particular telephone system.
Up
Select
Down
Latch
Battery pack
Lip
NetLink e340
Wireless Telephone
(back and left side)
with Battery Pack ajar
