SpectraLink Corporation
Installation, Setup, and Maintenance
NetLink SVP Server
Part Number: 72-0178-00-J.doc
Page 25
NetLink Telephony Gateway System Configuration
The following screen displays the options for the NetLink Telephony Gateway system
configuration:
•
SVP-II Mode:
Set to
NetLink
if using a NetLink Telephony Gateway.
•
Ethernet link
: The SVP Server will auto-negotiate unless there is a need to
specify a link speed.
•
System Locked:
This option is used to take the system down for
maintenance. The default entry is
N
(No). Set it at
Y
(Yes) to prevent any new
calls from starting. Return to
N
to restore normal operation.
•
Maintenance Lock:
The system automatically sets this option to
Y
(Yes) after
certain maintenance activities that require reset, such as changing the IP
address. Maintenance Lock prevents any new calls from starting. Note that the
administrator cannot change this option. It is automatically set by the system.
Reset the system at exit to clear Maintenance Lock.
•
Inactivity Timeout (min):
Set the number of minutes the administrative
module can be left unattended before the system closes it. This number can be
from 1 to 100. If it is set to zero (0), the administrative module will not close
due to inactivity.
•
QoS Configuration:
Select this option to set the DSCP tags and the 802.1p
tags. See
QoS Configuration
section.
•
Reset System: I
f this option is selected, you will be prompted to reset the
NetLink SVP Server upon exiting this screen.
The NetLink SVP Server should be reset at the end of any
maintenance procedure that requires a reset either via
Maintenance
Lock
or manually via
Reset System
.
Note that resetting the NetLink SVP Server will terminate any calls in progress.