SpectraLink Corporation
Setup and Administration–NetLink Wireless Telephone
(With SpectraLink Radio Protocol and NetLink Telephony Gateway)
Message Description
Action
DHCP error (1-4)
(con’t.)
DHCP Error 4
The server offered the Wireless
Telephone a lease that is too short.
The minimum acceptable lease is
24 hours. The Wireless Telephone
will stop trying. Reconfigure the
server and power cycle the
Wireless Telephone.
Erase Failed
Download process failed to erase the
memory in the Wireless Telephone.
This operation will retry.
Operation will retry but may
eventually report the error "int.
error: 0F" Power cycle the phone.
Erasing Memory
Wireless Telephone has determined
that a download should occur and is
erasing the current software from
memory. This message also displays
a progress bar. When the progress
bar fills the display line the erase
operation is complete.
None. When the progress bar fills
the display line the erase operation
is complete.
Internal Err. # #
The Wireless Telephone has
detected a fault from which it cannot
recover.
OE = Error while writing the Flash
(return Wireless Telephone to
factory)
OF = No functional code (contact
SpectraLink Technical Support)
Record the error code so it can be
reported.
Turn the Wireless Telephone off
then on again.
If error persists, try registering a
different Wireless Telephone to
this telephone port.
If error still persists, contact
SpectraLink Technical Support and
report the error.
Multiple GW regs
The Wireless Telephone has
discovered more than one
Telephony Gateway that is
configured with the Telephone’s
MAC address.
Check each NetLink Telephony
Gateway for the Wireless
Telephone’s MAC address on the
Telephone Line Configuration
screen. Delete any duplicate
entries leaving only one entry on
the correct Telephone Gateway
and port for this Wireless
Telephone.
Network Busy
All APs are full or busy
Try call again later.
Wireless Telephone not registered
on Telephony Gateway
Verify that NetLink Telephony
Gateway is properly configured.
NetLink Telephony Gateway is not
working
Verify that NetLink Telephony
Gateway is powered on. If so,
follow standard NetLink Telephony
Gateway troubleshooting
procedures.
No Gateway Found
No LAN connection at the AP or
NetLink Telephony Gateway
Verify NetLink Telephony Gateway
connection to LAN and all APs.
No IP Address
Invalid IP
Check the IP address of the
Wireless Telephone and re-
configure if required.
PN: 72006509B.doc
Page 27
