SpectraLink Corporation
Installation, Configuration, and Administration
NetLink Telephony Gateway
Part Number: 72-0065-02-R.doc
Page 13
3.
Installation and Configuration Steps
Installation and configuration has several phases. In some cases, a separate person is
responsible for each phase. It is important to coordinate the activities among the
persons involved.
The customer or vendor installs the APs per the
Configuration Note
for the AP being
used. This is normally done before the NetLink Telephony Gateway installation, but
should be done before step 3 below.
The first two steps are usually done by the customer up to the point of installing and
connecting the NetLink Telephony Gateway(s) to the telephone demarc blocks and
LAN access device. At that point, a qualified SpectraLink installer assists the
customer in completing the remaining steps.
1.
Site Preparation
: Done by the customer or a wire technician/contractor.
2.
NetLink Telephony Gateway Installation
: Done by the customer or
SpectraLink.
If five or more NetLink Telephony Gateways are to be installed, a NetLink SVP
Server is required and would also be installed in this step.
3.
NetLink Telephony Gateway Configuration
: Done by the customer or
SpectraLink.
Conditional:
NetLink SVP Server Configuration
: If a NetLink SVP Server has been
installed, its configuration would also be done in this step per
NetLink SVP
Server: Installation, Configuration, and Administration.
4.
NetLink Wireless Telephone Configuration
: Done by the customer or
SpectraLink per
NetLink Wireless Telephone: Configuration and Administration
.
5.
System Certification
: Done after installation to confirm the system is working
properly per
NetLink Wireless Telephone: Configuration and Administration
.