SpectraLink Corporation
Installation, Configuration, and Administration
NetLink Telephony Gateway
Part Number: 72-0065-02-R.doc
Page 38
Enter –0 to –12 for zones that are earlier than GMT and +0 to +12 for zones that
are later than GMT. Example: Mountain Standard Time is –7, or –6 during DST.
SNMP
: Simple Network Management Protocol: Enter the IP address of the SNMP
server to allow alarms and other simple events to be sent from the NetLink Gateway
to the SNMP server. More specific configuration information is not sent.
MIB Support:
SpectraLink currently supports SNMP V2c (also known as community-based V2).
The supported MIB is MIB2 and includes the following:
SNMP MIB
IP-MIB
TCP-MIB
UDP-MIB
IF-MIB (interfaces)
EtherLike-MIB (Ethernet interface)
The following custom MIB definitions are available on the SpectraLink website at
http://www.spectralink.com/softwareUpdates
:
SPECTRALINK-ENTERPRISE.TXT
NETLINK-COMMON.TXT
NETLINK-CAPABILITIES.TXT
IGMP
: Internet Group Management Protocol:
Yes
enables,
No
disables. This is used
for managing multicast traffic. It should typically be set to
Yes
.
Maintenance Lock
: The system automatically sets this option to
Yes
after certain
maintenance activities that require reset. These are indicated in this list with an arrow
bullet. Maintenance Lock prevents any new calls from starting. Note that the
administrator cannot change this option. It is automatically set by the system. Reset
the system at exit to clear Maintenance Lock.
Press Esc to return to the
NetLink Wireless Telephone System
menu.
Note that resetting the NetLink Telephony Gateway(s) will terminate
any calls in progress on the NetLink Telephony Gateway(s) being reset.
All NetLink Telephony Gateways should be reset at the end of any
maintenance procedure that requires any one NetLink Telephony
Gateway to be reset either via
Maintenance Lock
or manually via
Reset
System
. Resetting them all keeps the NetLink Telephony Gateways
synchronized, which is important for proper system function.