page 6 of 8
Pairing handheld transmitter & controller
lighting
The handheld transmitter is already paired in the factory and ready
to use. In case a problem arises, the pairing process can be done as
below:
Manual Pairing process:
Make sure the PL-REM-60 is connected to a power source.
1. Press (and release) the Pairing button on the small circuit board,
inside the controller (the button is close to the antenna).
2. Press the COLOR button on the transmitter (and release).
3. Press the ON/OFF button on the transmitter (and release).
If the transmitter is paired correctly, the red LED on the small circuit
board will light up, every time a button is pushed on the handheld
transmitter.
Red LED
Pairing button
