5
INTENSITY VERIFICATION
To ensure your EDGE™ 13 UV-A LED flood lamp is operating at the required UV
intensity, it should be checked periodically. Spectroline offers a variety of radiometers,
accessories, and kits for ensuring device maintenance. The AccuPRO™
(XP-2000) readout unit features a single dual-wavelength sensor detector designed
to measure both ultraviolet and visible light. For more information about these
units, please contact the Customer Service Department at Spectro-UV.
ENVIRONMENTAL CONDITIONS
The EDGE™ 13 lamps are designed to be safe under the following conditions:
• For Indoor/Outdoor Use (dustproof and protected against low pressure jets of
water);
• Temperature 41°F to 122°F (5°C to 50°C);
•
Mains supply voltage fluctuations not to exceed ±10% of the nominal voltage.
LIMITED WARRANTY
The warranty policy for the EDGE™ 13 is provided on the Certificate of
Limited Warranty enclosed separately with each unit.
NOTE:
For assistance
of any kind, please contact the Customer Service Department at Spectro-UV.
Provide the model, the serial number of the unit, and the date of purchase.
The unit’s serialization information is located on the back of the housing. If return of
the unit to the factory is deemed necessary, shipping instructions will be provided.
If an estimate of charges for non-warranty work or other service work is required,
a quote will be furnished upon evaluation of the unit. Out-of-warranty service work
will not be performed without customer approval. Use only replacement parts
supplied by Spectro-UV. Use of any other parts may damage the unit and will void
the warranty.
SHIPPING
Please be prepared to provide the model number and serial number of the unit
when you contact the Customer Service Department at Spectro-UV. Carefully pack
the unit in the original shipping and packing material. Ship the unit prepaid to the
factory and reference your Spectro-UV Return Material Authorization number on
all paperwork. Be sure to insure the unit for full value.
The AccuPRO™
(XP-2000) Kit
