`
06
www.spectrumcontrols.com
Copyright ©2015 Spectrum Controls, Inc., all rights reserved. Part No. 0100249-04 Rev 9/2015
1
2
3
4
Wire the comms module to the display as shown in the above wiring diagram.
Connect power as shown in the above wiring diagram.
With CAT5 cable, connect the comms module to an unmanaged switch.
Connect the unmanaged switch to both your PC and PLC with CAT5 cable.
IMPORTANT – PC & PLC must be in the 192.168.1.x subnet!
Please follow these instructions to setup the P22R display.
Setup for 2706-P9xC2-SC
2706-PENETK2-SC
Eth1: 192.168.1.100
PC
PLC