InVision Nano Table Installation only
0118583R4 Page 4 of 4
925 FIRST AVENUE, CHIPPEWA FALLS, WI 54729 / 800-235-1262 / 715-723-6750 / WWW.SPECTRUMFURNITURE.COM
1. Remove the (4) screws shown.
Figure 7.1
.
2. Remove end panel.
Figure 7.1
End panel
Remove these screws
Remove these
screws
Note: To install the Display Stand on a Nano table,
the end panel must be removed prior to installing.
1/4-20 Flanged
serrated locknut
(4 required)
3. Align the studs and insert the upright into the worksurface
mounting holes.
4. With a second person holding the upright, install the (2) inner
1/4-20 Flanged serrated locknuts.
Figure 7.2
.
5. Replace the end panel.
6.
Install the (2) outer 1/4-20 flanged serrated locknuts.
7. Tighten all locknuts securely.
Figure 7.2
Upright assembly
200mm VESA adapter plate (optional)
Attach 200mm VESA
monitor using these
(4) holes
Hanging rail
(4) 1/4-20 Keps
nuts to secure
200mm VESA
adapter plate
Figure 6
Note: The included adapter plate is for 200mm VESA monitor
applications. To install, align the adapter plate posts with the
hanging rail mounts and secure with 1/4-20 Keps nuts.
