Electrical Power:
The "D" Series IP cameras operate from a variety of power options including IEEE compliant POE devices.
• The power supply used with this product shall fulfill the requirements for Safety Extra Low
Voltage (SELV) and Limited Power Source (LPS) according to IEC/EN/UL 62368-1 or
IEC/EN/UL 60950-1 or Listed Class II Power Source Equipment. The product shall be
grounded either through a shielded network cable (STP) or other appropriate method.
Camera Location:
The "D" Series IP camera must be installed in a suitable location away from impacts, heavy vibration and
extreme heat. The "D" Series camera must not be installed in an area classification for which it is not rated.
The "D" Series camera must be attached securely and appropriately to a wall or supporting structure.
CAUTION:
The electrical cover should never be removed unless
power is removed (for at least 5 minutes) from the unit or the area is
known not to contain explosive materials.
13
WARNING
• The product shall be installed by a trained professional.
• The product shall be used in compliance with local laws and regulations.
• Store the product in a dry and ventilated environment.
• Avoid exposing the product to impacts, shocks or heavy pressure.
• Do not install the product on unstable brackets, surfaces or walls.
• Use only applicable tools when installing the product. Using excessive force with power tools
could cause damage to the product.
• Do not use chemicals, caustic agents, or aerosol cleaners.
• Use a clean cloth dampened with pure water for cleaning.
• Use only accessories that comply with the technical specification of the product. These can be
provided by Spectrum or a third party.
NOTE:
D201-1-Q6055 REV 4 105607312018 D SERIES
INSTALLATION MANUAL REV-1
General Safety and Operating Information:
