STANDARDS & CERTIFICATIONS
9
D201-1-Q6055 REV 4 105607312018 D SERIES
INSTALLATION MANUAL REV-1
STANDARDS-
The equipment is manufactured in accordance with the IECEX scheme, the ATEX Directive 94/9CE and with the
following standards :
IEC 60079-0:2011
IEC 60079-1:2014
IEC 60079-31:2013
IEC 60529:2013
EN 60079-0:2012 + A11:2013
EN 60079-1:2014
EN 60079-31:2014
EN 60529:1991 + A1:2000 + A2:2013
ANSI/ISA 60079-0:2013
ANSI/UL 60079-1:2015
ANSI/ISA 60079-31:2015
ANSI/IEC 60529:2004
CAN/CSA-C22.2 No. 60079-0:2015
CAN/CSA-C22.2 No. 60079-1:2016
CAN/CSA-C22.2 No. 60079-31:2015
CAN/CSA-C22.2 No. 60529:2016
Specific Conditions of Use:
-The flameproof joints of the equipment are not intended to be repaired. Consult the manufacturer if dimensional
information on the flameproof joints is necessary.
-Follow the manufacturer’s instructions to reduce the potential of an electrostatic charging hazard on the surface
of the equipment in Group II and III environments.
-The equipment meets the requirements according to the low level risk of mechanical danger. Therefore, the
equipment shall be located and installed such that the risk of impact or other mechanical damage is reduced or
avoided.
NOTE:
Use a clean cloth dampened with pure water for cleaning.
CERTIFICATIONS-
CERT NO. FM17US0156X & FM18CA0103X
Class I Division 1 Groups B,C,D T6,
Ta = -20°C to +55°C
Type 4X, IP66/67
Class II/III, Division 1, Groups E,F,G T6 Type 4X, IP66/67 Ta = -20
°
C to +55
°
C
Class I, Zone 1, AEx/Ex db IIB+H2 T6 Gb Ta = -20
°
C to +55
°
C, Type 4X, IP66/67
Zone 21, AEx/Ex tb IIIC T85
°
C Db Ta = -20
°
C to +55
°
C, Type 4X, IP66/67
CERT NO. FM18ATEX0057X & IECEx FMG 18.0020X
II 2 G Ex db IIB+H2 T6 Gb Ta = -20
°
C to +55
°
C, IP66/67
II 2 D Ex tb IIIC T85
°
C Db Ta = -20
°
C to +55
°
C, IP66/67
